SuperRunner
New Member
- Messages
- 657
- Location
- orem, ut
Got the upper intake all done and so now I can actually run the motor.
The thing SCREAMS. I still need to take the lower manifold down and put it on the belt sander to smooth it out. Got warped slightly from welding, so my idle is around 1500rpm.
Got the flywheel bolted on, and working on the extension housing for the shifter. It will sit back 31" from the motor.
I left my heater on in the garage so I have to go back(30 min each way). I will take the video camera and my good camera with me and get some decent pictures and a quick vid.
The thing SCREAMS. I still need to take the lower manifold down and put it on the belt sander to smooth it out. Got warped slightly from welding, so my idle is around 1500rpm.
Got the flywheel bolted on, and working on the extension housing for the shifter. It will sit back 31" from the motor.
I left my heater on in the garage so I have to go back(30 min each way). I will take the video camera and my good camera with me and get some decent pictures and a quick vid.