kc95sc400
New Member
- Messages
- 524
- Location
- Charlotte, NC
Lex,
I am going to use an intercooler, but have not sourced one yet or decided how big of one I want.
I've seen that one on your products page and it's a little expensive for my budget.
I am also wondering how in the heck to run the piping on the driver's side with the a/c receiver dryer, ps/hydro fan cooler and all the lines in the way.
I have a couple of questions for you, if you don't mind.
Do you know if the V-9 has the same bolt pattern as the V-1/V-2?
Do you remember how you ran piping on the original fish?
Do you know what size pulley is needed to blow 10-psi?
Can the drain line be tapped into the steel oil pan, or does it have to be in the sub pan? Drilling and tapping a hole in the sub pan really kind of scares me.
Thanks,
Khris
I am going to use an intercooler, but have not sourced one yet or decided how big of one I want.
I've seen that one on your products page and it's a little expensive for my budget.
I am also wondering how in the heck to run the piping on the driver's side with the a/c receiver dryer, ps/hydro fan cooler and all the lines in the way.
I have a couple of questions for you, if you don't mind.
Do you know if the V-9 has the same bolt pattern as the V-1/V-2?
Do you remember how you ran piping on the original fish?
Do you know what size pulley is needed to blow 10-psi?
Can the drain line be tapped into the steel oil pan, or does it have to be in the sub pan? Drilling and tapping a hole in the sub pan really kind of scares me.
Thanks,
Khris