B25
New Member
- Messages
- 17
- Location
- United States
hey, Im working on a 1uz swap and Im trying to make the engine work without any ECU or digital programming.
I have run into a problem with the igniters that send power to the
ignition coil assemblies(at least im pretty sure thats what they do.)
the igniters are fired in time by a computer, and I wondered
if there was any way to use a standard ignition coil(or two) to bypass them?
just take off the igniter and coil assembly and then wire (and belt) up two ignition coils from 4 cylinder engines?
thats very vague, and I apologize, but I am sort of teaching myself this
stuff as I go.
thanks!
I have run into a problem with the igniters that send power to the
ignition coil assemblies(at least im pretty sure thats what they do.)
the igniters are fired in time by a computer, and I wondered
if there was any way to use a standard ignition coil(or two) to bypass them?
just take off the igniter and coil assembly and then wire (and belt) up two ignition coils from 4 cylinder engines?
thats very vague, and I apologize, but I am sort of teaching myself this
stuff as I go.
thanks!