Michael LeCompte
New Member
- Messages
- 15
- Location
- arcata, ca. usa
Has anyone used Eric @ TTC's adapter to put a 5 speed (either r154 or w58) behind a 1uz in a sc400?
The adapter is 19mm thick...
I'm wondering the right combination of gearbox input shaft length, bellhousing, clutch shifter and driveshaft to make it all work.
Any advice would be appreciated.
I'd go v160 but I just can't bring my self to spend $3K to row my own at this point.
The adapter is 19mm thick...
I'm wondering the right combination of gearbox input shaft length, bellhousing, clutch shifter and driveshaft to make it all work.
Any advice would be appreciated.
I'd go v160 but I just can't bring my self to spend $3K to row my own at this point.
