4000GT
New Member
- Messages
- 2,043
- Location
- Christchurch, New Zealand
Ok so I got a Niteparts flywheel, a brand new QM twin rally disk clutch, a QM hydraulic release bearing... and it slips. Badly on the dyno, and now with much throttle. So its dead.
I think the best option is to go for a single 10 inch disk and suitable flywheel, and ditch this setup.
Can the QM release bearing be used with the bigger single type clutch covers ok? Or just the 7.25"?
Geoff, Choke on Smoke got something to help me out?
I think the best option is to go for a single 10 inch disk and suitable flywheel, and ditch this setup.
Can the QM release bearing be used with the bigger single type clutch covers ok? Or just the 7.25"?
Geoff, Choke on Smoke got something to help me out?