Another V8 supra

[Damo_supra]

I don't know what to do yet, I really don't want to cut into the bonnet.
At the moment I'm getting it tuned.
I can't shave the manifold, because of the intercooler inside.
If I have sufficient room around the crossmember and frame, I might shave the engine mounts. Will see when I get the supra back.

 

[Damo_supra]

I asked Andrew for a 15psi pulley and got a 10-12psi pulley (88mm).
So if I was supplied with the right pulley, it should clear the bonnet.
I think the 15psi pulley is around 70mm??? correct me if I'm wrong.
But if that's the case, then it should clear.
I'm surprised I got the manifold for the 1UZ and not the LS1!

 

[JustenGT8]

I asked Andrew for a 15psi pulley and got a 10-12psi pulley (88mm).
So if I was supplied with the right pulley, it should clear the bonnet.
I think the 15psi pulley is around 70mm??? correct me if I'm wrong.
But if that's the case, then it should clear.
I'm surprised I got the manifold for the 1UZ and not the LS1!

LOL does seem to be a recurring theme

 

[Damo_supra]

This was from a fairly safe tune as we still need to get into the timing a bit more, so I expect a little more...

View attachment 9680

 

[Damo_supra]

From memory around 2500rpm full boost.

Good luck with yours!