Temp Sending Unit for Electric Fan Conversion...

[avalon42]

Hi,

Noob here. I was reading through the Electric Fan Conversion Tutorial and saw that the temp sending unit should be placed on the drain plug near the water pump? Anyone have a pic of where that is?

Also, where could I get the 20mm to 3/8 adapter?

Thanks in advance.

 

[madmont]

You can see mine on the plug on the water inlet next to the water outlet
http://users.tpg.com.au/mtleslie/project/27.jpg

 

[Lextreme II]

Actually I have one.... $30 shipped. I got for like 45 usd but never used.

David

 

[avalon42]

Actually I have one.... $30 shipped. I got for like 45 usd but never used.

David

The Adapter or the temp sender? I got a temp sender from your buds at PartzFinder on order...is that the same one?

So it just goes in there right where you fill the coolant huh? I gotcha.

 

[avalon42]

You can see mine on the plug on the water inlet next to the water outlet
http://users.tpg.com.au/mtleslie/project/27.jpg

Nice...is that Teflon tape ur using to seal the adapter and the temp sender?

 

[madmont]

Yes as a matter of fact it is

 

[Lextreme II]

I just have the temp sender.

 

[avalon42]

Where would I buy the adapter? Home Depot?

 

[avalon42]

You can see mine on the plug on the water inlet next to the water outlet
http://users.tpg.com.au/mtleslie/project/27.jpg

Where did you get the 3/8 to 20mm adapter from? Trying hard to find it...

 

[madmont]

I drilled and tapped a 1/8 bsp hole in the plug