361UZ
Member
- Messages
- 167
- Location
- Canberra ACT
Greetings all, from Oz.
I am installing a 1UZ from a Crown in a Street rod.
The engine when in the Crown is tilted over to allow space for the steering box.
I wish to install it "upright".
Obviously this will mean the gearbox is tilted - not an ideal situation (I think).
I see from a previous post that I can use a Soarer (or similar) bell housing - IF I can source one, but is there another solution?
Can the bellhousing be re-drilled at the gearbox end so the gearbox can be rotated a few degrees?
THanks.
I am installing a 1UZ from a Crown in a Street rod.
The engine when in the Crown is tilted over to allow space for the steering box.
I wish to install it "upright".
Obviously this will mean the gearbox is tilted - not an ideal situation (I think).
I see from a previous post that I can use a Soarer (or similar) bell housing - IF I can source one, but is there another solution?
Can the bellhousing be re-drilled at the gearbox end so the gearbox can be rotated a few degrees?
THanks.