- Messages
- 4,790
- Location
- Houston, TX
First, this isn't about running nitrous in my motor, it's about using nitrous nozzles and jets to spray methanol for a M/W injection system.
Second, since I don't know squat about nitrous systems, I don't even know if this is feasible, but the thought occurred to me, so I thought I'd float it here and see what other folks think.
Currently I'm running two methanol nozzles, a 375 ml/min & a 225 ml/min, which have orifice sizes of 0.030" and 0.022" respectively.
Do nitrous jets come in these sizes or smaller? I've only heard them referred to as "50 shot" or "150 shot", rather than their actual orifice size.
If the nitrous jets are in about the same size range, I may try to pick one or two of them up and see what sort of spray pattern they produce in comparison to the M/W nozzles.
Second, since I don't know squat about nitrous systems, I don't even know if this is feasible, but the thought occurred to me, so I thought I'd float it here and see what other folks think.
Currently I'm running two methanol nozzles, a 375 ml/min & a 225 ml/min, which have orifice sizes of 0.030" and 0.022" respectively.
Do nitrous jets come in these sizes or smaller? I've only heard them referred to as "50 shot" or "150 shot", rather than their actual orifice size.
If the nitrous jets are in about the same size range, I may try to pick one or two of them up and see what sort of spray pattern they produce in comparison to the M/W nozzles.