Inlet Flange

[Alan Whitaker]

Hi All
Just had a inlet flange done, its a cad for a flange not a full machining cad file. I am going to use a 20mm ally plate (just what I have on hand), will have it cut but not the ports, just a small dia port cutout which is included in the drawings, going to get a cad file done just for the ports, worth a go for $22.
Let me know what you think.

http://www.ebay.co.uk/itm/121510744407?_trksid=p2060778.m1438.l2648&ssPageName=STRK:MEBIDX:IT

Alan

 

[vinnythespud]

hi Alan, i was thinking about getting this from ebay, have you had the flanges cut yet and were they ok? the inlet manifold studs on my engine are at a funny angle, does this flange take that into consideration or would i need to make some angled spacers.