Search results

Last year i put a quad cam Crown motor into a seventy series toyota land crusier What a truck . The latest project is to fit a 1990 Celsior motor into a jet boat . Looking through the forum i found good information on wireing diagrams and how to wire up , Looked like it should be simple to do...

Have fitted a 131 and auto into a70 series land crusier and dont have a ect to run the trans and cant seem to find one here in NZ .was thinking of using a speed controler out of a V6 hilux . Looking for comments or sugestion Cheers michael

Have a fitted oil pressure gauge to the crown 131 engine i have fitted in to a70 series land crusier . But is cranking out 60 +lb can any one tell me where the oil pump pressure releif vavle is located . cheers michael

On the front of the intake chamber is a large vacum port when i start the engine it is drawing full vacum. Could some one please tell me what it is for and what it would normally be attacthed to

Im half way through putting a crown 131 into a 70 series land crusier .This vehicle is a 24 volt and auto , have used the crown auto and adapted the transfer case on to the transmisson . Solveing the issue of a 24 volt vehicle and 12 volt engine took a fair bit of brain power .But in the end had...

Trying to start v8 have ome computer but no relays and fuse box etc ,have used k dogs wireing diagrams but can not get an igni signal via a timing light throug ht lead to comfirm im powering up the right places is there a limp home or cross over and or test that can be done at the diagnostic...