Search results

Last year i put a quad cam Crown motor into a seventy series toyota land crusier What a truck . The latest project is to fit a 1990 Celsior motor into a jet boat . Looking through the forum i found good information on wireing diagrams and how to wire up , Looked like it should be simple to do...

Just got back from a four wheel drive club meeting and have read everyones reply thusfar i really do find it hard to beleive that these pressures are normal when most after market gauges only read 60 to 80 lb and the gauge i have at present had the needle go right around to the needle rest pin...

Have fitted a 131 and auto into a70 series land crusier and dont have a ect to run the trans and cant seem to find one here in NZ .was thinking of using a speed controler out of a V6 hilux . Looking for comments or sugestion Cheers michael

Have a fitted oil pressure gauge to the crown 131 engine i have fitted in to a70 series land crusier . But is cranking out 60 +lb can any one tell me where the oil pump pressure releif vavle is located . cheers michael

thanks just what i needed to see

where dose it normally hook up to

On the front of the intake chamber is a large vacum port when i start the engine it is drawing full vacum. Could some one please tell me what it is for and what it would normally be attacthed to

I machined out drive gear and pto gear. Mounted on to hollow shaft with drive spline inside, bearings at each end to match od of transfer case bearings. In theory if you where to assemble the transfer case you could just slide the transfer on to the transmisson and bolt it up and away you go but...

Im half way through putting a crown 131 into a 70 series land crusier .This vehicle is a 24 volt and auto , have used the crown auto and adapted the transfer case on to the transmisson . Solveing the issue of a 24 volt vehicle and 12 volt engine took a fair bit of brain power .But in the end had...

thanks guys earthed ignigtor better and had a signal via the timing light . powered up the feul pumps and she burst in to life. could not keep it runing as dont have exaust on or the trans to transfer case adapter bolted on . next step is to locate the apropreate ect to run the auto does anyone...

is this via the ignitor body it self

Trying to start v8 have ome computer but no relays and fuse box etc ,have used k dogs wireing diagrams but can not get an igni signal via a timing light throug ht lead to comfirm im powering up the right places is there a limp home or cross over and or test that can be done at the diagnostic...