How about this rods?

[kengs4s]

Have anyone know about this rods ?I saw it can support too much HP.please advice me.

 

[kengs4s]

http://www.xatracing.com/fohrofor1uz.html

 

[cribbj]

No idea about those rods or that vendor. Be careful.

These rods: http://www.lextreme.com/Toyota-Lexus-Rods.html fit well, and will hold the power. Many of us run them in our supercharged/turbocharged 1UZ's & 2UZ's.

 

[kengs4s]

Thank you cribbj,
Have any idea with lextreme rods with CP pistons?

 

[kengs4s]

Thank you cribbj
Have any idea about lextreme rods with CP pistons?I love CP more Ross so I have to buy many shop that I'm afraid that will make clearance's problem .

 

[cribbj]

No personal experience with CP in these engines, but I'm sure someone here must have tried them.

I've had Wiseco in one engine and they were fine, and now I have a set of Ross in another motor which has only been broken in, but hasn't seen boost yet.

 

[XR8tt]

I have used C.P's from Subaru to Iron Eagle Dart Ford motors..
They are particuly good with forced induction..
I find some other forged pistons [Esp off the shelf] to be a little light around the crown due to boosted engines..
IMO...
They are up with J.E and Diamond pistons...
Btw have you checked http://www.spoolimports.com/spool-conrods/toyota/toyota-1uz-fe-conrods...
We've used them on 4.0 SOHC turbo Ford at 560RWKW to 7500 rpm @ 22Lb boost with C.P pistons..

 

[ash]

i use ross and JE

 

[FoPar]

we use Ross pistons and Argo rods on the 1UZ, making close to 1200hp atm and all good *touch wood* rods are rated at over 2000hp

 

[Zuffen]

My Ros pistons see 21psi every time I drive it (which isn't too often!) and they are going very well.

 

[XR8tt]

we use Ross pistons and Argo rods on the 1UZ, making close to 1200hp atm and all good *touch wood* rods are rated at over 2000hp

That's GOOD to hear !!!