Gilmer drive pullys

[ftruckn]

hey guys just wondering if anyone has made or makes a kit for the 1uz for a gilmer drive system for eaton m112 charger

cheers

 

[Zuffen]

Not to my knowledge but i don't doubt Richwood Technologies could do it.

You must want to run a heap of boost to need a Gilmer Drive.

I run 22.5psi on an Opcon and don't have belt slip problems.

 

[ftruckn]

its more for looks mate. thanks ill cheack richwood.

 

[ftruckn]

thanks heaps for the info, is yours adapted onto the front of the main pulley and just runs the SC?

is it standard gilmer belt spacing or did you get it made to suit the rb26 belt?

was if fabbed from new or a gilmer pulley from a kit to suit other engine?

any info is great thanx

 

[ftruckn]

does anyone know the pitch for standard gilmer pulleys?

thanks mate ill see if my mate can make me some up down here first, any troubles you ran into?

what material was used?

does just the main bolt run through it then 2 bolts on each side going through the original pulley arms (inside)?

thanks mate