bolts for bellhousing to 1uz block

[mynameismudd]

Hi

I was wondering if anyone could tell me the pitch and size of the bolts on the back of the motor. I picked up some m12 standard pitch and they were too darn big. DOH! I was going to pick up some m10s tonight but if anyone knows what exactly they are it would save me some time and energy!

Looking to get my motor on the stand this weekend.

Thanks!
-Matt

 

[cribbj]

The six top holes are M12 x 1.25, and the four lower ones are M10 x 1.25.

The top holes are the easiest to use for an engine stand, but the bolts may be a bit more difficult to find as the 1.25 thread pitch is a fine thread, and most hardware stores stock the coarse (1.5 or 1.75) if they stock any metric at all.

McMaster-Carr is your friend for these

 

[oneshot onekill]

hey

do u happen to know the lengths of the top and bottom bolts. I lost all mine