jibbby
New Member
- Messages
- 3,824
- Location
- Santa Monica, California
I have a good machinest and I am considering boring out a 4.0 liter 1uz-fe engine block....I have my hands on an extra block and it's collecting dust...The machinest is slow, now is the time.....
Question - What is the largest bore job that can be done on this block without compromising the structual block integrity?
2nd Question - What pistons should be used to match?
3rd Question - What a about the stock heads after the bore job?
I welcome any suggestions, info, etc... as I could not find the appropriate thread via the search engine...Also I would have put this in the engine section but I did not see anything for boring the blocks...
From my reads I am seeing that a 5.0L bore job is doable...
Question - What is the largest bore job that can be done on this block without compromising the structual block integrity?
2nd Question - What pistons should be used to match?
3rd Question - What a about the stock heads after the bore job?
I welcome any suggestions, info, etc... as I could not find the appropriate thread via the search engine...Also I would have put this in the engine section but I did not see anything for boring the blocks...
From my reads I am seeing that a 5.0L bore job is doable...