fugly
New Member
A few details and photos of my 1976 chrysler centura with a 1990 toyota crown v8 motor, a celsior sump, engine management, autronic SMC, gearbox 1990 toyota crown.
Gearbox controller, tiptronic controller made by Russel Koehne, extractors made using 1"3/4 mandrel bends by alex cranston, autronic wiring was done by Dave Kriedeman and Tuned by Ray Hall.
Fuel system, fuel tanks, breather tank & swirl pot were all fabricated by Jason Chalk.
I performed all of the mechanical installation/fabrication work.
Performance so far 214.3rwhp on a dyno dynamics dyno in shoot out mode, 14.3 at 167kph measured using a G-tech.
Last edited by a moderator: