Search results

Hey guys I need a Maf for my LS400.. I found out the hard way you dont clean it with carb cleaner.. If you could please help me out I would greatly apprieciate it. Thanks Dave

I have a R154 sitting here that was the spare for my car, but since I sold the car I no longer have a use for it. I am located in cleveland, ohio. The trans also includes the front drive shaft, crossmember, slave ect.. Im asking $550 and can be reached at 440-342-2412 Thanks

76mm GT42 non ball bearing garrett fresh rebuild H cover.. It has a 6" bell on the compressor and a 1.05 on the turbine side. The down fall is its T6 flanged (great for v8 guys) but a good T6-T4 adapter plate (only 3/4" thick) is under $100 with hardware... I have the collector and the...

How much boost out of a GT45r can a stock 1uz handle? Taken into consideration this will be on race gas(110 octane) with a 50/50 water/menthal injection. What about limitations to pump gas(94 octane)? Also I have 550's with a S-AFC II and the thicker cometic head gasket(.71 I think) with ARP...

Just what the topic says.. I am looking to simplfy my swap and the less wiring the better.. thanks, Dave

Hey guys I am new to the site but have been researching v8 swap(import ones) for the last few months. I pretty much came to the conclusion that I am using a 1uzfe and a R154 trans in my Rx7. My question is what can we do to these motors for the performance aspet(preferrable N/A) and what is...