Recent content by Oskido

I thought I should share this with all as I had no responses to my original request below by simply following a possible wiring to the fuel pump (Bosch 4.5bar) problem. "I've done all the testing required and replaced damaged Coils, Air Flow Meter and rest the computer. I still have a cold...

I NEED HELP!!

Does ANYONE have some advice on my problem - see thread!

Morning, I've done all the testing required and replaced damaged Coils, Air Flow Meter and rest the computer. I still have a cold start problem. Once I get the vehicle TO START without the Airflow Meter connected, it idles beautifully once running and when I then try to re-plug the Air Flow...

Can I have pics or advice where are both crank Sensor's situated on a 3UZ-FE VVT-i motor

I have a 3uz-fe motor & standard 5 speed gearbox. Replacing my Gearshift which is a A650 shifter and need wiring from gearbox to Shifter? Any takers - I've watched Grazy Tunes (Kelvin New Zealand) video but would like a wiring diagram if available?

Send all wiring to me!

Redoing my old Gearshift Unit - from standard 5 speed gearbox shifter to 5 speed A650 shifter

Hi, I'm no specialist but had a similar problem. Take your ECU unit out and plug into another 1uz-fe motor and see if you have the same problem. If so it's problem the immobilizer that needs rewiring/redone. My Immobilizer failed (replaced) and PC board rewired and walla - problem solved...

Hi, problem solved, immobilizer was the problem and PC redone. Vehicle now starts and runs 100%

Hi, I have PHD in IT Electronics and Systems. I'm not a PHD Mechanical Engineer motor vehicle engines - maybe you are and if not you learned along the way from ADVICE, HELP then Your comments are not welcome as considering "retarded". This website is to assist and see you a STAFF MEMBER and...

Could this be a Immobilizer Problem - if so, how do you bypass the Immobilizer on the 3UZ-fe VVT.i in my instance (without a OBD2 unit connection)? Remember this is per the instance in my previous email and setup of the motor, ECU, ECU wiring and fuse box - see attached images. Just as a note -...

Not retarded - if you read the email chain/thread and attachments supplied earlier you would have noticed that this V8 3uz-fe VVT-i has not been connected to the Isuzu Diagnostic Connector but in South Africa (and many parts of the world) these Chinese /Japanese motors arrive as one complete...

Hi, Diagnostic Test done and following is the problem - crank, short idle dies: On the home diagnostic I'm getting the following: Fuel Cut Solenoid signal problem detected (where is this situated on the motor)? EDU (Electronic Drive Unit) malfunction (where is this unit situated or is this...

Hi , Diagnostic Test done and following is the problem: On the home diagnostic I'm getting the following: Fuel Cut Solenoid signal problem detected (where is this situated on the motor)? EDU (Electronic Drive Unit) malfunction (where are this unit situated or is this part of a ECU problem)...