Landcruiser 100 2VZ transmission...

[The Surfer]

I was thinking that it may be possible to utilize the Landcruiser auto trans from a '98 up V8 behind a 1UZ to fit a 4runner or Surf etc... Does anybody know what the code for the trans. is? It should be A34? ? from the same family of transmissions etc as the LS400,Soarer, etc. Stout enough to take the power, Hopefully with the same number of solenoids,sensors etc... so the ECU combo from LS- Soarer etc will successfully operate it? Does anyone know what transfer boxes will fit the Cruiser gearbox?
I know this is an expensive possible solution but if it is simpler to wire up and works in a satisfactory manner then it could be an option.
Best regards, Richard.

 

[sbisig]

I just started looking into this option for my FJ80. I hope this is the info you are looking for.

The 100 series Land Cruisers from 1998 to 2003 had the A343F transmission.

From from the little research I have read, the bell housing will bolt up to the 1UZFE.

The same bell housing is supposed to bolt up to my FJ80 A440 transmission (using a 100-series flywheel).

Steve