MikeMan
New Member
- Messages
- 104
- Location
- Auckland, New Zealand
Hi all
Has anyone had a 1UZ head on a flow bench?
I am looking for flow rates every 0.050" to 0.600".
I have some engine simulation software that is pretty good, I have most of Kelfords cams input now and the head flow is the last item I need before I can build an accurate model for the engine.
Regards
MikeMan
Has anyone had a 1UZ head on a flow bench?
I am looking for flow rates every 0.050" to 0.600".
I have some engine simulation software that is pretty good, I have most of Kelfords cams input now and the head flow is the last item I need before I can build an accurate model for the engine.
Regards
MikeMan