92' 1uzfe port area

[striker]

does anybody know the port area for the 1uzfe non vvt engine?

and perhaps,
does anybody know if there is sufficient tapper in the intake port (towards the valves) and what rate that tapper is (preffer in %)

regards Thomas

 

[striker]

Noone???

grtz Thomas

 

[rms]

1.96 sq/inch

 

[striker]

thank you very much Errol

regards Thomas

 

[striker]

Errol one question is that including the injector cut-out or without?

grtz Thomas

 

[rms]

Without cut-out

Merry Christmas

 

[SCV8]

The taper is alright; about 2mm over the length of the runner.

 

[SCV8]

Another thing to note; the manifold mounts at an angle to the centerline of the port, so if you just measure the gasket, you will get a false, larger number than reality. The port itself is equal to a 38mm Dia. section, and flares up to 41.5 at the plenum, approx.12.5" runner.

 

[striker]

Brilliant SCv8

that's worthfull info.

thanx alot to the both of you!

grtz Thomas