M.Rad.
New Member
- Messages
- 5
- Location
- Austin, Tx.
Hi everyone- I recently installed a replacement motor in my 97 SC400. It starts and runs pretty well, but I'm getting a canister purge code now.
In my haste, I didn't label all the vacuum lines, and in addition, I deleted the power steering pump vac. lines, so now I'm not sure I have the canister purge going to the correct ports.
If anyone could post a vacuum diagram, or an engine bay picture showing the proper vac. hose routing, I would be most grateful.
Regards,
M.R.
In my haste, I didn't label all the vacuum lines, and in addition, I deleted the power steering pump vac. lines, so now I'm not sure I have the canister purge going to the correct ports.
If anyone could post a vacuum diagram, or an engine bay picture showing the proper vac. hose routing, I would be most grateful.
Regards,
M.R.
