Parts 1 Uzfe For Sale

[qca]

Non Vvti New Water Pump And Timing Belt Fitted , Oil Pressure And Compression Very Good Mid Sump Fitted Not Run Since Parts Fitted $1300 Aud
Also Available W58 Supra Box With Bellhousing Clutch , Flywheel All Parts Needed To Fit Up To The Above Engine Retail $2200
Ready To Go (has Not Been Used) $1750 Aud.

Lexus V8 Coffee Tables , Plate Glass Oval Top Can Be Etched With Logo, Lex / Toy. Stripped Bare Block Sits On Bellhousing End Plate Glass Sits On Oil Pump End
They Weigh Approx 30 Kg Use The Cylinder Bores To Hold Those Anoying Remotes And The Main Caps Hold Dvd's Or Cd Cases Perfectly Also Great As Display
Bargain At $475 Aud

Thanks Pete Qca 0400 888 432

 

[bansheebuzz]

will you sell the w58 separate?

 

[qca]

i would prefer too sell all together but i'm willing to haggle .
I have too many engines
and would like too get at least one sold
i have 4 coffee tables (bare blocks) 2 short engines 1 vvti 4 complete engines 2 engines in cars 12 in total so somthings gota go !!!!!!

 

[Peewee]

Pic of coffee table?

 

[qca]

swap ya a piccie of the coffee table for a tune for the microtech

 

[Peewee]

A) can't download tunes from Microtech yet
B) the tune is for 440cc injectors
C) even if you had 440cc injectors the car would still drive like ****.

 

[qca]

do you have an early std engine tune ?
trying to set pictures but there 1.1mb and they wont upload

 

[Peewee]

Nah, we over-wrote the old tune with the new one.

Once Microtech releases the software to download the tune to a file then I'll start storing them, but they haven't done so yet.

All you can do is either store them on the dongle, or on the hand controller.




As for the picture, open it in MS PAINT, and Image->Stretch/Skew->50%,50%->OK->SAVE