Search results

I put a Crown 1UZ FE into a VH commodore and have decided to sell. Not because I am unhappy with it, but because I need the money (unfortunately). For those who are interested:- *I modified the mid bowl by rotating it 180degrees and moved it back 100mm by making an adapter plate up. This...

Hi, Here is the problem: Sometimes when i put the car in drive, it just sits there (like it's in neutral) and doesn't move until i rev it a bit, then i quickly goes into gear and goes forward. It also does this in reverse. It also does it when i drive along, then if i don't keep the rev's...

I have my 1UZ-FE in my car and was just about ready to go in for the roadworthy then i ran into this! I changed the rear upper trailing arms on my car (VH Commodore) along with a couple of other bushes and the brakes, then when i put the car down and took it for a drive there was a huge...

Does the water level in the radiator have to be higher than the suction and discharge outlets for the motor? Because my radiator is about 50-100mm below the inlet/outlets on the motor. I am asking this because i pulled the suction hose off my car today and it was dry inside the motor. There has...

Does anyone know where I can put a mechanical water teperature probe in the block? Thanks

here is a question for the exhaust manifold gurus.... I have bugger all room to put extractors, but what i wanna know is, is there that much difference in gained power from extractors to a nice flowing set of manifolds? I have seen some photos of some extractors on the net and they are huge! I...

Hi What is the maximum boost that the 1UZ-FE standard ECU can handle? And does anyone recommend a certain brand/type of supercharger for this? The engine is a crown royal saloon 1991 model. Thanks.

KDOG, I have a 1991 model crown royal saloon. I am unsure what the UZS131 is that you were referring to. My engine is the 1 UZ-FE. are the diagrams u posted the same for the 1UZ-FE? Thanks

Can anyone here send me some pics of some engine mounts to give me some ideas. Thanks. I have some VH engine mounts here and would be looking to make some sort of adaptor up to fit the 1UZ-FE. Thanks

hey hazard, if u end up getting your hands on a wiring diagram, could u please let me know. I am chasing one too. Thanks

Hi all! This is the best forum I have ever seen. Keep it UP! I am putting a 1 UZ-FE in a VH Commodore. I have only just started the project and was just wondering if there are any tricks for the youngsters I should look out for. I have just gotten then engine out of the half cut and it is now...