Search results

wondering if anyone has some std valve buckets out of early 1uf-fe. i need 10 in good condition. thanks im in australia.

has anyone tried this and is it worth it. is their much work involved. do you have to change retainers and what buckets to use. thanks

how many milliseconds of dwell works best with the standard ignition system. thanks

does any one know what is a typical shim sise for intake and exhaust valves on the 1uz heads (27mm shim)? i am ordering a shim kit and dont want to order too many of the sizes i wont need eg 2.00 mm. thanks

need opinions. thinking of running two turbos off s13 motor (t25's i think). would thes be big enough for the 1uz or would it be a waste of time. Reason: they are cheap from a wreckers. give me your thoughts please.

can some one please confirm with me if SLU red/white is the wire for tc lock up and is located in the plug for s1 and s2 if not which wire is for tc lock up. also what is SLN solenoid 4 used for? Thank you

i am running a stand alone and want sequential manual shift. does anyone know if rigging up the selector switch on side of tranny, so when drive is selected you can opperate the solenoides by other means than moving the shifter. basically i want to put it in drive and up and down shift via two...

thinking of going turbo and wondering if anyone has had any problems using a tee of the oil pump pressure switch to feed the turbo. thinking this might starve the motor of oil any sugestions welcome. thanks

having throuble with ems 8860 ecu on crown 1uz (no spark) Can someone please tell me if the crank sensor is the trig output or is the cam sensor. I am using the left bank cam sensor or should i be using the right bank. not registering any rpm when cranking. also do the ignition coils fire when...

I stuffed up. I have removed the cam belt tensioner thinking it was the spring for the fan belt tensioner. does any one know if i can just bolt it back on or will my cam timing now be out. thanks

(1uz-fe) Thinking of running a stand alone ecu which does not provide sequential injector fire(EMS stinger 4). all the injectors fire at the same time. Can any one who has run this type befor be able to tell me if they noticed a substancial drop in fuel ecconomy. The next model up from the...

has anyone tried removing the belt driven fan and replacing it with an additional electric fan? would you get enough cooling and what temp should it be engaged

hi want to run an aftermarket ecu but dont want a manual gearbox does anyone know what you have to do to make it manual shift( so it dosn't need ect)

does anyone know the std oil capacity of 1uz crown

I need to ges some alluminium plate laser cut so that i can make my own sump. has anyone had this done before and where. How much would it cost

can somebody please give me the wiring diagrams for the 1uz crown or tell me where to get them

i have a 1uz middle sump. i need a rear sump. e-mail if anyone has one. [email protected] thanks Tom

i have a holden hq and i am trying to fit a 1uz motor in it. the motor i have is out of a crown and has a middle sump. i need a rear sump does any one know what model has a rear sump and where i can get one