Search results

  1. S

    1UZ parts

    I got mine from Autopro so any spare parts supplier should be able to get one for you
  2. S

    any ideas? running on 4 cyl

    Check coils igniters & triggers for a start
  3. S

    ID

    Just bought another motor for the 37 and just wanderin what i've got. I was told it was Soarer but from what i have read on here i think it might be an ambulance motor. It is rear sump but instead of plastic covers on the front it has a large cast alloy plate with the alternator mounted at the...
  4. S

    Locked engine

    Well haven't got it totally stripped but removed the cam belt and cranked it over but had no oil pressure so must be a problem in the oil pump somewhere. Hope to get it out tommorow and see what gives. Unfortunately in the Chev it is a major job to get it out:dunno: :dunno:
  5. S

    Thermostat housing options.

    You got me there. No i don't work on late model cars ,just use the running gear. The rad hose issue is something that i just took for granted and set up like all the other stuff i have done but will have to look at changing my setup now although have not had any cooling problems at all. Just...
  6. S

    Thermostat housing options.

    Don't know about the car you have but every car i have ever worked on the thermostat goes to the top of the radiator not the bottom. Water pump supply to the bottom.
  7. S

    Supplier and part numbers for good aftermarket o2 sensors

    I got mine through Autopro. About $40 ea from memory
  8. S

    Locked engine

    G,day all, have searched all through this site but have not found anyone with this problem. I have a 1uzfe in a 37 Chev which has been running fine for the last 12 months and done approx 8000km's since it went in. I was taking it to have the trans flushed and got about 35 km's from home when it...
  9. S

    Parts Soarer and 1uz parts for sale:

    Hey hungry4info, have pm'd you about some parts last week but haven't heard anything back???? Still interested so please let know.
  10. S

    1uzfe starts then stalls. Engine conversion

    I found the problem with mine was i hadn't plugged the coil back in properly when i had the thermostat housing off. Plugged it in and all ok. Funny though when i was running it with the lpg you couldn't tell that it was only running on 4 cyl apart that it wouldn't rev properly but i put that...
  11. S

    1uzfe starts then stalls. Engine conversion

    The 1uz in my 37 has just started doing the same thing. Thought it might have been bad fuel so flushed the system and replaced with fresh fuel,fitted new plugs but won't keep running and it was fine last week when i parked it. I disconnected the fuel pump and ran a hose from an lpg bottle into...
  12. S

    Wanted oil filter base

    I could have told you that:slomo: :slomo:
  13. S

    Wanted oil filter base

    Pm me your address Dave and i will post it over.
  14. S

    Diff Gears Question.

    I'm running a Toyota Hi-ace diff 4.33 in my 37 Chev with 275/60 15 tyres. About 2600rpm @110 kph
  15. S

    Wanted oil filter base

    Dave why do you want to run a remote. I made a 90 deg housing for mine to face the filter out the front like a holden v8. I do have a couple of filter housings here that came off front sump setup. I will have a look tommorow coz i think they are both different. Pm me your address if you want me...
  16. S

    Trans problem

    Thanks for the reply sideshow. The motor and trans were out of a Celsior. The wires i used were off the 3 wire speedo sensor.
  17. S

    Trans problem

    First of all thanks to spf lexus for the reply to my original question but unfortunately the line pressure test didn't make any difference. I spoke to MV automatics and also took it down for him to have a look at it and of course it did everything it was supposed to. He suggested it sounded like...
  18. S

    Trans problem

    G'day all, iv'e got a bit of a problem with the trans in the 37 (1uzfe). It seems like it skips a gear when you take off, starts in first but feels like it jumps to 3rd or od and won't kick back until it gets a bit more speed up. If you change manually it works fine. Any ideas:dunno: :dunno:
  19. S

    Speed Limiter!?!?!?

    Any more info as to where to find the switch or jump wire:439: :439:
  20. S

    New to jap V8's

    Haven't had time to check things yet but started it a couple of times on Sunday and always rich. Went to start it again and started but only on a few cylinders and wouldn't keep going. Disconnected one coil at a time to see if it was a coil but both worked sort of. Tried again tonight but...


Back
Top