Has anyone replaced their Rear outer lower control arm bushes. The bushes are actually located in the hub. Does anyone know where you can buy just the bush, as toyota wants to sell me the entire hub.
I wouldnt be driving it like that. It would be driving on the bump stops. Using either the the diagnostic port in the cabin or the one in the engine bay, jump Tc and E1 with some wire. The dash will then flash up some error codes. Count the flashes. 3 flashes pause three flashes would be 33...
Use some "running in" oil. Just make sure the car is running rich as the fuel will wash the oil off the walls of the bore allowing the rings and bore to bed in. Dont use LPG, as there will be no washing effect and the rings wont bed in , speaking from experience a car running on LPG...
You can use babelfish to convert to english, you just have to install the japanese fonts on internet explorer
http://babelfish.altavista.com/
They are listed as being for ucf10/11/20/21, ucf11 being the air suspension model. Theys a guy in australia that buys them and get them posted here for a...
I just bought some height adjustable coilovers from japan for $1500 aust delivered. They should be here in a couple of weeks. My front right died and was going to cost $1000 aust delivered, so $1500 seems reasonable.
http://page2.auctions.yahoo.co.jp/jp/auction/b66572001
I have a celsior Speed control computer and a LS400 speed control computer, and had them apart side by side. The only noticable difference is that J1 jumper missing. I think it will work.
http://www.andysautosport.com/product/suspension/coilovers;jsessionid=DC5E23ADB046D591F93C20C485193397?_v=vmd00257
Any idea why different manufacturers have different year model specs?
Anyone know for sure if ucf10(1989-1994) and ucf20(1994-2000) suspension can be swapped? I'm looking into some secondhand tein coilovers, but they are from a ucf20. I have a ucf10.