redsautorehab
New Member
- Messages
- 5
I am working on getting ready to do a 2uz swap into a 1990 4runner, and sourced the bellhousing, and flywheel from akina motorsports in Tempe, AZ. The flywheel is the one supplied without the ring gear. it looks like the one available in NZ, and Australia. Akina motorsports is selling a clutch kit with a Toyota pressure plate, so it's a factory setup, just not sure for what. They want to sell me the one they have, but it's $425, and I am cheap. The space for the pressure plate measures 10.5", and the dowel pins are evenly spaced between the bolt holes, where most Toyotas have the dowel next to one of the bolts. The clutch kit for the 4.0l engine looks right, but the disk is .25" too big, and the pressure plate is too big as well.
Flywheel: http://www.akinamotorsportz.com/1jz-2jz-w58-bell-housing/1uz-flywheel
Clutch kit: http://www.akinamotorsportz.com/1jz-2jz-w58-bell-housing/1uz-replacement-clutch-kit
Anybody have any clue what clutch this uses?
Flywheel: http://www.akinamotorsportz.com/1jz-2jz-w58-bell-housing/1uz-flywheel
Clutch kit: http://www.akinamotorsportz.com/1jz-2jz-w58-bell-housing/1uz-replacement-clutch-kit
Anybody have any clue what clutch this uses?