new to do list:
-tap oil sending unit for turbo feed
-figure out where to have my turbo drain
-mount I/C
-flip intake manifold to driverside
-start fabbing manifolds
questions that i have:
1) what do i do with the vacuum lines that go into the intake mainifold? p/s, fpr, iacv, etc. now that BOOST is in the picture.
2) now that i am going to flip my intake manifold, can you cut and extend the MAF wires without throwing off the sensors reading? not exactly sure.
-tap oil sending unit for turbo feed
-figure out where to have my turbo drain
-mount I/C
-flip intake manifold to driverside
-start fabbing manifolds
questions that i have:
1) what do i do with the vacuum lines that go into the intake mainifold? p/s, fpr, iacv, etc. now that BOOST is in the picture.
2) now that i am going to flip my intake manifold, can you cut and extend the MAF wires without throwing off the sensors reading? not exactly sure.