jibbby
New Member
- Messages
- 3,824
- Location
- Santa Monica, California
I'm curious to know what the largest most successful engine bore that has been performed on the 4.0L Xuz-fe engines?...
Being that the engine block is alluminum how thin can those cylinder walls become before the engine block structural integrity is compromised?
I think we have seen some 5.0 engine bores done but not sure...
Who knows what is the largest engine bore ever done on these blocks? Any guesses are welcome too...
Being that the engine block is alluminum how thin can those cylinder walls become before the engine block structural integrity is compromised?
I think we have seen some 5.0 engine bores done but not sure...
Who knows what is the largest engine bore ever done on these blocks? Any guesses are welcome too...