New profile posts

Bei ON7G findest du eine große Auswahl an Ausmalbilder für jedes Alter. Ob Tiere, Mandalas oder Fantasiewelten – hier wird jeder fündig. Ideal zum Entspannen, Lernen oder kreativen Gestalten. Einfach herunterladen, ausdrucken und loslegen. ON7G macht Malen zum Erlebnis für alle.

84 celica 1uz swap
78 lancer 1uz swap
81 corolla liftback
81 corona liftback
85 corolla 1uz swap
86 corolla

hi sudsy i am interested in your 1 uzfe ecu maps mate i have an old mercury unit that has been in a cupboard for about 8 years .i was using a haltech until the windscreen leaked and ended its life . cant get any sort of help from spitronics ..hoping you can help me out .

Hello could you email me the 1UZ wiring diagram you found ?

Pour un swap de fan hydraulique sc400, la braquet du gs 400 fonctionne tu?

WHAT ARE THE PINOUTS FOR LF MANIFOLD PLUGS FOR COILS CPS HARNESS CANT FIND ANYWHERE

hi zuffen.

i need help with my g/box wiring. on which pin do i connect the etc-pwr switch and on what pin does the o/d button go? ecu-3a240 1uz non-vvti a341e
as best i can tell there's no OD2 pin. there's a PWR-(28pin5) PWRL+(28pin6) and OD1(28pin7).

appreciated
hugo

1992 sc400 1 st owner put 50,000
i put 50,000 miles
changed oil every 2,000 miles
clean body no rust
just put in rotors
pads, calipers
belt, water pump
paint good, rear spoiler faided
driver seat shower wear
starts right up
bad stuffs a stumble on hare acc
changed almost every thing
under hook still stumbles
it drives me nuts i can't find it
the stumble
a
well taken care of
$5000.00

Did you sort out measuring the engine in the end? I seem to be having the same discrepancies as you!

Best wishes

Chris

Do you still have that front sump you were looking to swap?

My car idle roung on hills whether down or up but worst in an upward position what can be the possible reason for that or can cause it

Hey Ben, I saw your scimi project on your website. You mention trunnion replaced by jag ball joint. from what I can make out it looks like you used a complete jaguar lower wishbone and vertical to achieve this? Are you able to tell me whether this was taken from an XJS model? It's hard to make out but it looks like it might be? Any issues with camber/caster compared to original wishbone setup?

Are you guy I need to talk to rebuild engine harness

Doubt you’ll respond but I’m the new owner of your car and would love to ask some questions about it!

hi
New to the forum. Did you ever start building parts to marinize 1Uzfe.

thanks for sharing. I am wanting to do same to my t100. I am glued to this

The bell housing I’m looking for fits between a 92 Lexus 1uzfe and a 86 Toyota G52 manual Tranny. To clarify my question does anyone know which vehicle uses the same bell housing in a 4x4 toy or Lexus?

I have 1uz vvti with a dicktator management the engine misfires and have a high idling.The spark plug are black.What could be the problem guys

Hi guys thanks for letting me join, I’ve just bought a Lexus 1 UZ engine to put into a boat and would be grateful of any information about the modifications I need to do. Thanks guys.

Active