Raiden
New Member
- Messages
- 1
- Location
- East Coast
hey guys, here's what i got:
http://www.92sc400.blog.com/
what i'm looking for:
basically looking to remove as much restriction down there as possible. Right now it seems all i have on are a couple of cans, i'm looking to free up some horsepower but i'm not sure where to cut or what to weld.
When i do this i'll document the whole process and share it with you all.
http://www.92sc400.blog.com/
what i'm looking for:
basically looking to remove as much restriction down there as possible. Right now it seems all i have on are a couple of cans, i'm looking to free up some horsepower but i'm not sure where to cut or what to weld.
When i do this i'll document the whole process and share it with you all.
