bluebottle
New Member
- Messages
- 2
- Location
- Istanbul
how high can you rev a fully built 2UZ?
built bottom end, built head.
built bottom end, built head.
max engine speed on a built 2UZ
- Thread starter bluebottle
- Start date
The 1UZFE EGR Delete Kit is available for sale here.
XR8tt
Active Member
- Messages
- 2,758
- Location
- Sydney Australia
Hmm ?? Cam specs etc would be nice..
I would rev to 8500 rpm street engine...
Depends on weight of assembly etc???
Drag racing can be higher due to short rev duration ...
Above 8500 it would be expensive to maintain IMO..
I would rev to 8500 rpm street engine...
Depends on weight of assembly etc???
Drag racing can be higher due to short rev duration ...
Above 8500 it would be expensive to maintain IMO..
- Messages
- 4,790
- Location
- Houston, TX
I would agree with XR8TT on the 8500 limit.
That's assuming you have good rods and good hardware on the bottom end, and it's all been well balanced, plus you have good valves and valvetrain on the top end to minimise bounce. As XR8TT mentioned, cam ramp profiles are very important for this.
That's assuming you have good rods and good hardware on the bottom end, and it's all been well balanced, plus you have good valves and valvetrain on the top end to minimise bounce. As XR8TT mentioned, cam ramp profiles are very important for this.
Similar threads
