Search results

I am after a Air Flow Meter for the 1uz as I believe mine is on its way out. Preferably in QLD 0422381474 Cheers Andrew

I have a 1UZ in a SWB Landcruiser which was wired by sideshow Over the past few months I have noticed the motor develop a bit of a miss and have been searching for the problem since(it also has a strong fuel smell. I have since changed plugs, leads, swapped ignition modules for some spare...

Just after some help as my 1UZ has started to run really rough. Some background on the truck its a Toyota Landcruiser Bundera (LJ70)4x4 and I had Sideshow do the wiring back in November/December. It was running fine for about 4 months when one day out on tracks it started to run a little...

I have a 1UZ in my SWB Landcruiser Bundera and over the past month or so I have noticed that once the engine gets up to operating temperature the idle drops(which its suppose to do) however it starts to run rough and trys to stall. It also if left will stop. I have tried looking for a dodgy wire...

Over the last few weeks I have noticed that the car feels down on power and down low sounds very loose and different almost like it had blown a hole in the muffler(but there isn’t). It was driving like that fine and I wasn’t overly concerned and I hadn’t had any time to look into it further...

Has anyone got a piccy of the plug for the rear sump? I have put a CRS rear in and cant seem to locate this plug everyone talks about!!! Im probably just blindor looking in the wrong spot. Thanks Andrew

For those who have fitted them do you know what size lengthxwidth these are....I have ordered them in a 2.5" but the 3" is the same size cylinder. My exhaust is getting done in the next few days and we are just making up a dummy bit of pipe to take their place until they arrive

As the title says I need the early crown 3 pin ECU Preferably in Oz Cheers Andrew

Hi I am in the progress of replacing my 2LT motor in my Toyota Bundera (LJ70) with a 1UZ. I bought the motor with the Auto still attached and I am not using it so I was wondering how do you remove it from the flywheel? Thanks Andrew