Search results

  1. P

    Long shot, but B/W / Tremec T5 question?????

    Zombie thread....are there drawings around for a 1uz bell housing to ford t5 adapter? Or at least drawings/measurements for the trans side bolt pattern 1uz bellhousing and bellhousing side bolt pattern ford t5?
  2. P

    1GZ-FE bellhouse pattern

    I'm in SF Not yet but I will probably get one as soon as I find out what it takes to connect one to a manual transmission. Another question, is the flexplate bolt pattern the same between the 2 engines?
  3. P

    1GZ-FE bellhouse pattern

    Is the engine side of a 1gz bellhousing bolt pattern the same as a 1uz? Or more to the point can I use a 1uz bell on a 1gz?
  4. P

    Chevy Rods

    bringing back a dead thread... I know nothing about 1uzfe engines but want to. I've been looking around at ways to use better rods and avoid custom pistons. A couple of questions... I've been looking at Ford modular rods....5.95" combined with ford/mazda duratec pistons. If my info is correct...
  5. P

    1gz-fe engine specs?

    Can any one tell me what the deck height is on the block and what the pin height is on the piston?
  6. P

    1gz-fe engine specs?

    any measurements?
  7. P

    1gz-fe engine specs?

    Andy R If you could you tell me what the deck height of the block is, pin height of the piston that would be great. Thanks
  8. P

    1gz-fe engine specs?

    Andy, are you able to source oversized bearings, rings and new valves?
  9. P

    1gz-fe engine specs?

    Thanks for the info. Like I said in my earlier post the Mitsu 6a13 v6 has identical bore and stroke with both a turbo and na motor so there is potential for less expensive pistons. Thanks to Andy R for the info on the con rod length, now I just have to find out what the 6a13 rod length is. What...
  10. P

    1gz-fe engine specs?

    Thanks, Ok, what I'm looking for is the rod length center to center, large and small end bore diameters, crank rod and main journal diameter... Thanks again, Justin
  11. P

    1gz-fe engine specs?

    I'm looking at getting one of these engines and I would like to know if anyone has specs more than borexstroke and so on. Specifically I'm looking for alternative sources for pistons. I would like to know how long the the con rods are. A Mitsubishi 6a13 vr4 engine has an identical bore and...


Top