Search results

This do not have TE1 plug. I plugged E1 with TC as pictures but check engine light remains on, with no blinks.

By the way, the engine is nunning with a non immo ecu, I just swapped the ecu.-

It isnt OBD2, It has the old plug. This type: Isnt important to connect the MPXs wires?

Hi, I am trying to run JDM 1UZ VVTi engine (originally coming with 89661-50450´s ECU) with a LS400 (USDM) 1UZ VVTi´s ECU (89661-3A464) that came with her key, coil and a IS300 amplifier (89783-5310). I Pluged the 5 amplifier´s wires as per attached diagram, place the key in to the coils and...

What happens when you run an immobilized engine? Does it starts and stops??? Did not starts??? Starts and stops and did not starts again??? Thanks

Its gone. Thanks!

Done. With DTC 15, checked the yellow/black wire of the right igniter and found that was switched with yellow/black of MAF. Now starts, but stop on idle with no new DTCs. Will check it tomorrow.-

Switch the right side coil and wire, ingniters and problem remain the same.-

I Got this codes: 15: Ignition Nr 2 21: Main O2 sensor L 27: Sub O2 Sensor L 29: Sub O2 Sensor R 56: ??? 78: ??? Question are, What means and what is Ignition 2??? Cant find codes 56 and 78 (fuel pump maybe) Thanks guys.

Hi again I am trying to make run a JDM 1UZ FE second generation. Specs are: Ecu plugs: 34/22/16/28 Ecu N#: 89661-50241 B/R wire feed EFI and W wire feed sensors. The engine starts, but when should down revs and continue in idle, it stops. With or without MAF the problem remain the same Enough...

Finnaly make it runs. The harness has similar colors to what I see in many of the diagrams around, but the B/O wires was B/R and the B/R was White. Thanks guys.-

I bought the LS400 1996 manual, but cant find the pinout of that plug.

Is still working? Trying to find some manuals in to the russian page but can read anything neither find downloads :confused:

Can I please? To [email protected]

Those are the wires (colors)

Hi Can not find the engine loom to body loom 26 pin connector for a ~96 Jdm 1UZ FE. The Ecu is a 34/22/16/28. This is the body loom connector, that does not match with colors in the 80/40 ecu.

Sorry to be rude, forgot to say hello! ...and compression picture

Cant find in the forum. So, what is the manufacturer compression pressure of a 1 uzfe (out of crown magesta)?. Mine has around 210.