Search results

Do you need to do anything to the STA pin?? Mine, in the 40 40 40 pin loom is actually part of the loom that goes from the engine straight to the computer.

I don't think so, the runners look too long. If you look in http://www.lextreme.com/forums/showthread.php?t=11174 Those headders will fit with some modifications.

Lextreme has a plate that can be threaded to suit the braided hose fittings, but you still need the relocating kit. I have just done this on mine. Brad.

Can I have a look at it when I am in perth next week and make a decision then?? Brad.

How much do you want for the non trac control throttle body??

I would be interested as well, just depends on how thick it is. Brad.

How much for them?? I will be in perth next week.

What are the rotor caps and rotors like??

Thats $1000 a side.

Landed cost was about $300, had to open out the bolt holes on one side because they didn't line up properly. The front runner misses the steering shaft cover by about 10mm, i may put some heat bandage in that area. I will probably mod them, change the 3 bolt flange to a 2 bolt flange, will...

I bolted mine to the engine today and test fitted in the engine bay, and guess what, they don't fit. The left side o2 sensor hits the torsion bar, and the flanges are bit out of line. Looks as I have 2 options, 1 - Modify the headers to fit (cut and re-weld) or 2 - Put in a 2" body lift and...

I think he means Hydraulic fan

Have you cleaned all the crap out of the holes in the socket?. On my half cut my cabin diag port (big round socket under steering wheel) was full of grease and it made it hard to trace the wires.

Hi, I need to make a new oil pump pickup tube for my conversion. I have seen some around, but can't find any piccys of them. What I would like to know is do I have to use a steel or stainless tube or can I go with a copper one. Bracing would be needed for either one, but copper would be...

They will fit, but I am yet to try them in the truck. Brad.

It is the short shaft that goes between the auto and transfer case for 4wd. Brad.

I am at that stage in my conversion to start working on the auto. What I would like to know is, is there any benefit to replacing the Lexus auto output shaft with the Hilux one, or is it easier to just cut the shaft to the length and go with that?? Cheers, Brad.

Thanks Gloverman. At least I know that it is all supposed to be there. DBB, Sorry, I did have the front quarters, but they looked in good condition, but they were full of bog and therefore dumped. Cheers, Brad.

They will all be under the plastic covers on the top front of the motor.

No worries, Thanks anyhow Aaron, it was a good starting point.