Search results

Thanks for the pointer on the 3RZ bolts, I've tracked down some. As said above they are 33mm long under the head with 12 point heads and the OD of the head flange is 21.2mm The Toyota part number for them is: 90910-02116 they were A$4.77 ea. +GST I asked the service guy what these were...

Thanks all that's useful information. http://euler9.tripod.com/bolt-database/22.html Anyone else gone with 12.9 bolts?

The 4AGE bolts are 26.7mm long which I don't think is long enough. The stock bolts are 25mm long so going through the flex plate and backing ring that leaves ~20mm of thread engagment (I dont have exact numbers to hand). The flywheel I'm getting made is 12mm thick at the bolt face and the...

Hi All, Anyone know where I can source flywheel bolts to the spec in the title? Looking at the ARP catalogue I can't see such a thing. Thanks,

Hi XR8tt, Thanks for that, i was actually thinking about the OD of the thing though. I haven't got around to doing it yet but pulling the support bearing from the inside of the end of the crank and reading the numbers on it will pretty much give the xact ID of the thing. Thanks, Doug.

Hi All, I'm about to go hand a drawing over to a shop to get a flywheel turned up. Hopefully I can read a set of verniers but just to check with people as it obviously a critical thing, what is the diameter of the crank spigot? I measure a diameter of 41.80mm. Thanks, Doug.

Hi All, I've done a bit of search and not found what I'm looking for so here goes... My application is mating an Audi 012 (Porsche Boxster 5 speed) to the 1UZ-FE. What flywheels are known to have the same bolting pattern as the 1UZ-FE crank? I don't care whether the ring gear matches as I...

I'm in the process of mating up an Audi 012 (Porsche G86) to the 1UZ-FE. Hopefully this work will result in commercially made parts being made available for that conversion (not made by me though). http://www.bncproducts.com.au/ These guys do 1UZ-FE to Porsche G50 they might be able to do and...

Posted not posed.

I think Erol has posed what he has already, if there is a full block drawing available I'd love to see it. And I'd be happy to share the resulting CAD model.

Erol, Thanks again, that setup sounds superb, mine will be just a bit less sophisticated!

Firstly I'm surprised how close i got with my original measurements, I guess I can use a ruler! Next on the drawing supplied the 4 M10 holes below the crank were not dimensioned, that leads me to think that might have been done on purpose for some reason, is there a reason not to use these hole...

Thanks very much.

Superb, thanks very much.

Hi All, My first post here I think. For my project I have a (you guessed it) 1UZ-FE to mate to a Porsche G86 (Audi 016) transmission from a 5 speed Boxster. Firstly I've never found anyone selling an adapter kit to do that so if you know of one that'd be great. I think its reasonable safe...