Recent content by smokey13

a/c has been removed cuz i did a motor swap into a jeep. i have read on here before and was for sure some one had a part # for one

looking for the part number for the belt with out ac searched but cant find it or the link to it

any help on this

ok just relooked my stuff over this might be it, the relay i have running my igniters and injector is running off pin 24 too is this the problem

no belt on the motor so alt not turning, no waring light hooked up. do i even need E9-24? (M-REL) drives the Main EFI Relay, i have this hooked to the ignition switch and everything works fine

i have followed this to the letter and it works. the problem i have is when i turn the key off it stays running until i pull Pin E9-24 out. this is what im using as a guide. i know this isnt for my ECU but i used it to wire up my relays

well after about 5 days of wiring and endless night on the net look for wire diagrams and drowning my frustrations with Natty Light, i got the whore running. now i got build my relay board tidy up the wires and have it done so i can move on to getting it road worthy. i still have to plum in the...

well after about 5 days of wiring and endless night on the net look for wire diagrams and drowning my frustrations with Natty Light, i got the whore running. now i got build my relay board tidy up the wires and have it done so i can move on to getting it road worthy. i still have to plum in the...

I plan on following this post by cuh8er to see if it helps but have some questions Do need to wire in a check engine light? What else do i need to wire in from the 40 pin plug im using an auto tranny but no traction control? Pin E10-77 (STA) is already run and uncut in the harness is it...

well doing the wiring is more time consuming then i was planing but its been fun. still not running yet but its getting there

X2 working with the same ECU

well its been a long time, but i just started the wiring on the jeep. i have3 all the wiring diagrams from here(at least i think i do) Been working on it for 4 days now but no start. is their a diagram that show where the wire go or hook to im afraid to of burning up the ECU if i haven't...

being in the military makes the build slow well here is an update to the jeep i got the tranny cooler mounted oil filter relocated and the fuel system done im moving on to the wiring. im hoping to have it running sometime in May this is the mock up stage

dose anyone have the pinout of this plug im down to doing the wiring and the fuel system and drive shafts and is there a site that has the pin outs of the 340 tranny and conectors some where

well it fits with the fan now had to cut out a cross member under the core support to do it but it’s in. I had to bake the front bumper to hold the frame together before cutting the cross member out. it will get to clevis eye and a receiver hitch put in it here it sets on 38.5x14.5 tsls