a recent brain fart has caused me to look for, 2 headlamp assy. and 2 fog lamps. also grill. for 12/89 lex ls400. email [email protected]. car is not perfect so a few blemishes are ok.. must be free of moisture
i-cooler manifold
what do you guys think about putting a custom made evaporator inside manifold under blower. tap into pressure and suction line in a/c system.you have the makings of a super cooled i/cooler that would increase the density of your intake charge. i've been drawing this up for a...
one of your rear bulbs or loose ground wire to individual sockets are loose. tighten all phillips screws holding ground wires to lamp sockets(plastic heats up and loses connection
reply to stalling
sounds like you carbon buildup on your throttle body and or idle speed controller need the same cleaning. do not spray solvents directly in t.b. lextreme has the procedure correctly listed in d i y tutorial. sensors will get shorted out if wet.good luck pm if you need more...
reply low idle
instead of guessing your problem eastern usa has auto zone/will scan car for free. or pay somebody for a code check, data stream. guessing could cost a bundle. bad coolant temp sensor/vacumn leak. air charge sensor,thermotime switch??????? scan for codes..... east coast i charge...
reset cd
most cd stackers have small hole in the unit reset hole must insert small object(toothpick/paperclip/ if not enter serial number on google search for downloading original manual
your right since 2 children i find myself thinking before doing. i was raised tostick up for family and my self.i just hate to see people get away with this. i have a auto shop and would never act like that. can't do the job cough up the dough.p.s there is only 1 uncle rocco!!good luck
the last bent pin i saw was on a chrysler v-6 mits/or nissan. the belt had jumped and was from a strike from piston to valve/maybe valve was repaired before you purchased motor.it's easy to overlook unless your changing cam seals
i did the whole upgrade for 210.. u.s i ordered beck-arnley complete rebuilds w/ caliper brackets. and my parts guy took the single pistons and brack. as cores. pays to buy from the same parts guy i use at my repair shop.also got 2 new rotors. much more meat than 1990 ls.
check live data stream readings iff poss. coolant temp sensor reading important.check for carbon ring on throttle plate. ive seen people drill small hole in butterfly(ford and some others) as not to lose tps signal from turning idle screw/check for air bleed screw. check stuck egr valve.or air...
reply to lights
toyota has a bad habit of using plastic as a point to complete ground circuit. there is a phillips screw holding bulb socket to light assy. this scew heats plastic and loosens connect. which causes higher resistance which causes bad lamp light to come on. check all dual filament...
reply help
dont quote me exact but most cars have a small cable lock to column to prevent key turn off/a locking steering while rolling.check for small cable running from shift to column or lock cyl the shifter is a shift interlock/ car must be in park to remove key so something releases a...