?Hi hypronet
Thanks for the info
I have the T8-a connectors on the ecu really what matters for me is the ign and +12v inputs of the ecu since I basically get the wiring almost complete without the fuse and relay boxes
So it seems that from the diagram you gave that the ecu needs ign to pin no...
Ok that sounds easy
I also have a friend who works as a key smith and told me he can tell if the car has a security ign key by looking at the key itself
On the other hand I read some other post on this site says that cable throttle will not operate the throttle fully and also that the ecu...
Well I can get the full half cut easily here in Dubai but I will not be able to see the ecu til I take the wiring apart
Is there any way to tell like from ecu
number or car model?
Or how the look of the harness ?
Ok guys it is time to go newer so I am trying to see if I can start and run properly a 1uz vvti 1998 99 jdm engine
I have one in mind the price is not bad so will get that out of the way
Two problems I can see
1- the engine does not use cable throttle so we need way around that
2- it seems...
This proves my point that the wiring for 96 LS400 on this site is different than JDM or other market for that matter
Any way I would assume someone knows what pin on the ecu needs 12v and what pin needs IGN for JDM engine I live to far to order ready made wiring
If some one knows and don't...
I have decided to use a delay relay for the fuel pump control it runs the fuel pump for an adjustable time and it will come off then it will run continually upon a trigger from the oil pressure lamp when oil pressure builds up
On the other hand I can't figure out witch pin needs ign input and...
My engine wiring seem different any way do you know which pin controls the fuel pump relay and power input to the ecu
For your engine not from the diagram?
Thanks 65gtmustang I expect the wire colors to be different but I could not find the 95 LS400 diagram
It seems I am not so good after all researching
Could you please post the link to it !
Hi
I ran my engine it is not exactly the same ecu number but same pin configration
On the last plug with the 28 pin you input IGN to the last pin to the right of the second raw and the last raw when looking at the pins into the ecu
Also you will find a big white plug ( Not Ecu plug) cut off...
Thank you 65gtmustang for the tip
I couldn't load the phot but The ecu part no. Is 89661-50380
Another number on ecu is 175000-9531
Has four plugs 34-22-16-28 pins
The engine is 1uz-fe front sumb it should be out of JDM LS400 1995,96 or 97 year model
Any help pls
Thanks