Recent content by bobwho80

"i was gettin error codes 83 84 85" I am getting those faults now too since I rewired the ls400 loom to suit crown.... What wires did you get crossed up or how did you rectify?

Hi guys, Well I have swapped to the crown ECU now, seems to be happy now (although seems not very powerfull) No fault codes initially on startup or anything but eventually after a while it brings up codes 83, 84 & 85... any ideas??? Radiator is in now, running a 12" thermo on one side and...

Hi guys, thanks again... I haven't swapped ecu's and probably wont for the same reasons... why change something that aint really broken? Still getting radiator sorted out so can't run for long at all, when the rad is in I can run it for longer times and see what goes on, esp with road...

Surprisingly, after looking at it today, I dont think it is set straight... didn't notice it till now, but hey... I only arrived halfway through the conversion... nah haven't done cambelt sideshow, don't think it's been touched. I reset the ecu today and ran it up during diagnostic, error 56...

Hi Guys, I have finally taken the camera in to take a few pics. I've gotten it started and running. It is however spitting out fault codes 13 (RPM Circuit #2?) & 56 (???) and not really wanting to rev, I am still running the std computer instead of crown ecu as I dont want to swap the pins...

Cheers guys, the spark leads have 1995 on them, has alloy engine mounts, not sure about air con... the guy is sure it's a soarer type engine tho....

Hey what was this about an intergrated a/t trans cooler lines??? I am trying to figure out what the two pipes are inbetween crank pulley and air con pulley on my supposed ls400 motor? one is big banjo bolt and the other is a flared pipe, about heater hose size... with oil in it that wasn't...

Hi guys, great replies, you all have helped me out lots. twisty_toy94 - I ended up removing the instr cluster and continuity checking the oil and water, thanks tho. I am still puzzled with the 3 wire speed sensor and need to re-add it into the loom again, are you able to help with what pins...

Hi guys, i've been reading this forum for a few months now, so many people have done these conversions it's great to see!!! However I've been given a tough job to do, and that's to finish off this 1UZ-FE into a 92 Hilux Surf VZN130... it's been left alone for a year and now it's my turn to...