Recent content by Anthug

  1. Anthug

    Hilux Surf LN130 1UZ-FE

    Truck Finished! Project now finished and goes great. All fully certified, even the 2" body lift which requires certifying. Now for sale on Trademe.
  2. Anthug

    Hilux Surf LN130 1UZ-FE

    Yes, still working on it after taking some time off to start up a new business. Back to it now and vehicle starts and runs. No test drives yet. Just modifying radiator at the moment by adding a cap and changing the bottom outlet direction to point upwards instead of to the right. Then sus...
  3. Anthug

    Hilux Surf LN130 1UZ-FE

    Hi, OD off runners approx 37mm & main tube 47mm. Anthony
  4. Anthug

    Hilux Surf LN130 1UZ-FE

    Exhaust done Right hand header Crossover pipe Keeping the standard turbo diesel exhaust from the trans crossmember back for now.
  5. Anthug

    Hilux Surf LN130 1UZ-FE

    Making the Exhaust Using 2" from manifolds into collector, then 2.5" to muffler. Bends Flanges & Collector Original manifolds shortened. Die ground inside, very untidy from factory. Right hand side
  6. Anthug

    Hilux Surf LN130 1UZ-FE

    Trans Mounted & Driveshafts in Installed the Transmission & Transfer Case. Transmission mount required modification as engine is mounted 30mm forward. Holes sloted and new holes drilled (not shown) Front Driveshaft shortened by 30mm & Rear lengthened 30mm.
  7. Anthug

    Hilux Surf LN130 1UZ-FE

    Joing Surf Loom with Lexus Loom Spent some more time on wiring. After lots of searching and reading have matched up the Surf loom & Lexus loom. Plan is to use Glow plug relay as Fuel pump relay and existing Surf Main EFI & Starter relay. Anthony
  8. Anthug

    Hilux Surf LN130 1UZ-FE

    Joined geabox & engine Chopped radiator support to make fitment easier due to low garage height
  9. Anthug

    Hilux Surf LN130 1UZ-FE

    Wiring Removed required wires/plugs from Surf engine loom
  10. Anthug

    Hilux Surf LN130 1UZ-FE

    Images Back up Finally have time to get back to working on the Surf after working on other vehicles/boats. Engine now in Auto trans not mounted yet so is leaning back a bit. Still playing with wiring. Anthony
  11. Anthug

    1uzfe into '84 Starlet

    Those mounts look much better, nice work.
  12. Anthug

    Hilux Surf LN130 1UZ-FE

    Please explain how this is the hard way?
  13. Anthug

    Hilux Surf LN130 1UZ-FE

    Modified Throttle Body Removed traction control and capped off one side. Barb is for Idle Valve.
  14. Anthug

    Hilux Surf LN130 1UZ-FE

    Engine Parts Replacement Replaced the following parts on engine: - Water Pump - Cam Belt - Tensioners - Idlers - Spark Plugs - Rotors & Caps - Starter Motor contacts - Accessory Belt Removed gears from inside of Hydraulic Fan Pump: Air Conditioning Pump Fitted (wifes request)...
  15. Anthug

    Hilux Surf LN130 1UZ-FE

    Exhaust manifolds are standard early LS400, just had a little taken out of the runners. Keeping the front sump and fitting replacement steering damper.


Top