88sogreatv8
Member
- Messages
- 86
I have a 88 Toyota Cressida , that is currently getting a 1uz swap out of a ls400. the factory left side manifold will not work with the steering shaft. I am contemplating using a sc400 manifold . It appears to be more streamline than the ls400's. I have already tried to modify a cheap tundra header off of eBay , which also didn't work.
Has anyone ran into this problem with their 1uz swaps. If so, what was the resolution? Any suggestions would be greatly appreciated!
Has anyone ran into this problem with their 1uz swaps. If so, what was the resolution? Any suggestions would be greatly appreciated!