rwdfreak
New Member
- Messages
- 67
- Location
- Montreal, Canada
I just got a nasty surprise when I took the clutch assembly off. It appears that when I heat shrunk the ring gear on the flywheel, the flywheel slightly bent backward. The flywheel now has a groove depper on the inside than outside and show signs of heat spot. I think the clutch and pp is shot.
I would like to give it a free start by resurfacing the flywheel clutch side face, but don't have the spec. Since I had a 5M clutch on it I assume it would be a similar two step definition but I can't verify that. Anyone has the spec for this flywheel?
I tryed emailig them but got no answer.
I would like to give it a free start by resurfacing the flywheel clutch side face, but don't have the spec. Since I had a 5M clutch on it I assume it would be a similar two step definition but I can't verify that. Anyone has the spec for this flywheel?
I tryed emailig them but got no answer.