Search results

I used a Flex-a-lite model #118 16" Puller on mine and it seems to work really good. Not sure what radiator you are using though. I also made a hood scoop on the hood to help with airflow. The temp gauge has never gone higher that what it did with the factory engine in it.

Hey guys I need to remove the key switch from the steering column on my SC400. I can't see how to do it. Any tricks to this?

The 2uz has OBDII emissons stuff and won't hardly run without it so you need all of it from the donor. It also has a drive by wire throttle so you need the gas pedal assembly and need to figure out how to mount in in your truck. The 2uz block is iron and weighs about 125 pounds more than the...

Thanks guys!

Here is a build thread in an 88 IFS 4Runner Start to finish. http://www.yotatech.com/f161/1uz-fe-into-1988-4runner-3-0-3vze-185324/

Here is my build up Thread. http://www.yotatech.com/f161/1989-pickup-1uz-fe-auto-dual-t-case-swap-207835/

not sure why that link won't work. http://banzai-racing.com/store/index.html

Sure no problem. The mounts I used are from a company called Banzai Racing. They are made for RX7's. I drilled out the holes a bit for my application...

Here is my writeup. http://www.yotatech.com/f161/1989-pickup-1uz-fe-auto-dual-t-case-swap-207835/

Just got my swap completed. Still have to comlete the body work but the drivetrain is done. http://www.youtube.com/watch?v=whvJbEh5q8o

The idler pulley assembly from a Tundra 2uzfe will fit too.

I have no idea what those attachments are about.

5 minute JB weld. Its lasted 3 years on my radiator.

Ok that makes sense. I guess the next question is what is the linkage going from the throttle down to the transmission for then?

Sorry for the noob question but what is the floor switch under the gas pedal on my 1992 SC400? It only activates when the pedal is floored.

How much does that cost Sideshow?

Yes. It has been done before.

4Runners Auto's from 88-95 Were the A340H. They didn't start using the A340F until the 1996 in the 4Runners(1995 Tacoma's). The A340H was a right side drop. The A340F models were a left side drop. this info is for US models. Not sure about other countries. The A340H was designed to share its...

There will be a few issues with the electronincs on your Taco transmisson and the Lexus computer. The easiest thing to do is use the lexus transmission and just use the output adapter from your Taco tranny. It should bolt right up. I think you can either cut the output shaft on the Lexus tranny...

Most of the best sites for this swap are in Australia or New Zealand. http://www.downunder4x4.net/forum/index.php? http://www.4wdmonthly.com.au/forum/ http://www.supracharged.com/ Wiring http://spw.starkie.net/ Bellhousing adapters...