Search results

I have a mate with a conversion into a hiace van And after a few minutes of running goes into limp mode I havent looked at it yet, just trying to find some info before i do Im told its got fault codes 4 and 7 Code 4 temp sender, he has tried a new one Code 7 throttle position, and he...

trying to sort out a new supplier at the moment, the new flywheels will be made to suit both 10" and 9.5" clutches, hope to have it sorted in the next couple of weeks

hey guys through a contact of mine can offer. Lightweight billet flywheel with integral ring-gear $480nzd ($351usd) 'standard' weight billet flywheel with integral ring gear $380nzd ($278usd) adaptor plate from 1uzfe to w55-9, $320nzd ($234usd) shipping from Auckland, New Zealand

hey guys im after a 1uzfe crank pulley, but a double belt type, i have been told the military spec engines have them can anyone confirm, or does anyone have one they will sell or part swap cheers si

if you have a gas set and can braze, why not get some steel filler rod and gas weld it instead, we use to repair cracks on manifolds by brazing, before i got a tig, it handles the heat ok, but dont think it would handle the load and flex etc.

IMO and no offence intended but they are a poor design in the collector, and i personally never use thin wall exhaust tube for turbo manifolds, let alone pressed collectors. i always use schedule 40 tube and bends, a lot heavier but a lot stronger, retain more heat and generally will...

i have just found out the ecu i have is from a 98-99 IS300. are the pinout different betweeen this and the later model? cheers Brad i have saved those pinouts and im hoping they are the same.

hey guys, i know this is primarily uzfe terrority but i need help i have an IS300, SXE10 2jzge auto ecu, i need to know the ecu pinouts. it is for a project we are undertaking, which involves a 98 2jzgte transplaned into a IS200. unfortunatly we sold the factory IS200 ecu and loom with...

in the past with other n/a toyotas bthat i have turbo'd, I have been sucessful by using a 2 bar map sensor from the likes of a 3sgte, upgrading the fuel pump, injectors and installing a rising rate fuel pressure reg. this has worked well for me on different engines, but would like to know if...

currently doing a 1uzfe conversion into a s13 silvia which i want to supercharge using an eaton m80 due to availability. what i want to know is will the factory ecu from a sc400 run with boost? i heard a rumour it will run up to 9psi is that correct? or what mod's do i need to make...

i considered this with my project, i used a 5mm plate profile cut to the sump shape, cost me $20 to supply steel and get profiled and i just drilled the holes my self, i was then just goin to construct it to suit also from 3mm mild steel plate. now since i have alloy welding equipiment im...