Search results

  1. R

    Parts 1uz to 350z 6sp adapter w/clutch and flywheel and trans

    I know super old thread but do you still have this by chance?
  2. R

    Want 2 psi more

    I have a v2 si with a 3.08" pulley and im running 6psi @6200rpm i want to get 2 psi more how much do i need to drop in pulley size to get there? i dont want any more then 8psi. I want to just over 300 at the wheels. Dyno with 6psi with the vegas heat at 275whp.
  3. R

    crank pulley diameter

    just for reference vortech v2 si 3.08 pulley intercooled 6psi @6200rpm if that helps any
  4. R

    Code P0100 on swapped pickup

    Hey i just swapped my 85 toyota pickup with a 97 non vvti 1uz have it started but runs really really rich black smoke, idle is high runs pretty much all around doesnt run well. Only code i pull is p0100 the rest are transmission codes but im 5 speed. I also ghosted 2 secondary o2 but no codes...
  5. R

    Need help with supercharger setup

    im sure there is a way but i dont see what the benefit would be. Is there a reason you cant use the stock setup for the pullies? I wouldnt worry to much about shavings i just flushed the motor with oil until i was satisfied. You could just drop the pan and drill and tap it.
  6. R

    sc400 supercharged dyno sheets

    Thanks you i was very impressed considering my stock dyno was 170hp with w58 trans... Roughly 6 psi at 6k rpm intercooled on vortech 3 vsi think temp outside was upper 90's
  7. R

    sc400 supercharged dyno sheets

    Just thought i would post what my sc400 put up on the dyno mind you it was 90 degrees plus out at night it is Vegas :D before tune first run was 252whp after tuned 270whp
  8. R

    what is a safe AFR?

    Ok cool thxs on stock injectors seems like I'm getting about 12 leans out to about 12.5 maybe I bump fuel prx up a little bit
  9. R

    what is a safe AFR?

    i have finally got my supercharged 1uz running good only running abut 6psi at 6000rpm what should my AFR should be?
  10. R

    Car gets hot with a/c on

    What would be your recommendation
  11. R

    Car gets hot with a/c on

    was getting it tuned so i didnt kill the motor with the safc
  12. R

    Car gets hot with a/c on

    Wonder when it sends the knock signal if it retards the timing making it hot prolly running lean right now with the extra strain of ac and heating it up just ordered a Afr wideband been previously just dyno tuning but that was with 440cc injectors took them out cause of how rich it was leaned...
  13. R

    Car gets hot with a/c on

    6 psi max it's a low boost setup
  14. R

    Car gets hot with a/c on

    Sard adjustable reg one step colder plugs and going to put mu apexi safc back on ...I had 440cc injectors in but way to rich ran
  15. R

    Car gets hot with a/c on

    I am stumped my car gets hot with the a/c I just supercharged it not a problem before....I installed a koyo tt 3 row supra radiator 160 thermostat 2 zirgo 14in fans with a shroud...ok so I can drive about 20-30 mins and it will start to overheat and get a ck eng light for knock sensor no...
  16. R

    supercharged sc400 running rich

    http://www.lextreme.com/forums/showthread.php?t=15835 this is the exact kit i got didnt think about it when i picked it up... found a guy that has some rebuilt by rc injectors im picking up trmw 460cc with flow sheet
  17. R

    supercharged sc400 running rich

    ok think i found the problem tested injector ohms part number 195500-1350 4 injectors were 15 ohms. 3 injectors were 25 ohms and i found 1 that was a 195500-1370 which i believe is a 550cc injector which ohm at open feel dumb lol but part number looked the same and it looked the same wow
  18. R

    supercharged sc400 running rich

    do you know what the coil packs are suppose to ohm out at? i appericate the help thank you
  19. R

    supercharged sc400 running rich

    Pulled plugs again have 5 cyl running really rich (black) the other 3 seem good brown and white


Top