Search results

na he isnt, but i play rugby and im a prop haha. had another look yesterday and the front wheels were were touching the wall which has a 200mm concrete lip and then two flimsy poles coming up with two boards across. it was alot closer than i thought to going over the edge.

Thought i would advise people who are doing manual 4x4 conventions to put a switch behind there clutch. as recommended on the Lextreme site cant remember where i found. my mate was adjusting something on my engine and he told me to start it. It was in 1st with the handbrake on it started up and...

i have just finished putting a pre vvti engine in my ln106 hilux didnt take much to wire up done the whole thing my self ( not certed yet) and it goes like a dream i had a 3l turbo(2.8 turbo) in it before this and there is no comparison, spins wheels just driving up my drive way with out even...

well i replaced the air flow meter i went average, but was still choking between 1000-3000/4000rpm(not sure no tacho at the moment) so i check the ecu it spat out to codes 21? not sure may have been 22 and 41 any way it was engine coolant temp and throttle position sensor, i had wired in an...

I think all cylinders are over fueling? it back fired out the intake about 3 times yesterday when i got it started, maybe all injectors are at 100% duty cycle? i dont know its got me stumped.

I think it is the 02 sensors, i will take them out and have a look at them tomorrow. i haven't taken any of the leads off at the dizzy caps so it cant be firing order and it revs out fine it just floods its self when the revs drop back down. so i don't think its a spark issue. could be...

also there is 12 volts at the B+ terminal in the diagnostic box

i just put a new fuel pressure regulator in as i broke the last one. and i have adjusted the TPS. there is a small hole in my exhaust and fuel is dripping out of it when the motor is running. i have to take the fuel pump fuse out and turn the motor over about 6 times to get it going and even...

Hi guys ive just put my 1uz in my hilux and got it all wired up. i replaced the plugs. the motor idles bad with black some and if i turn it off it doesn't start again i have to take the fuel pump fuse out and turn it over with the throttle half open and it fires after about 5 seconds, and today...

it cost me 100 for the fly wheel and 60 to get it re-drilled and the ring gear didn't need any alterations the starter engages fine.compared with the 350-400 for one off the internet

3sgte (Toyota mr2 gt) fly wheel and clutch assembly works best for street or track use.

warthog Do you know where to get a wiring diagram for a 40 40 40 pin ecu as i got my 1uzfe off trademe as well. Thanks.

Hi Do you know where to get a wiring diagram for the 40 80pin ecu? Thanks